Ignition Wire Sets
Proudly Assembled in the
has engineered a wire set line that is second to none in
every aspect of performance,
protection and coverage.
The purpose of good wire insulation is to protect the cable from voltage
leaks. The single most important factor for rating insulation performance
is the type of material used and not the diameter of the wire.
Silicone, while resisting temperatures up to 600 degrees
(F) will give you the greatest protection. Our
Silicone-over-Silicone cable includes two layers of high
grade Silicone for superior voltage protection. Common practice among most
wire set manufacturers is to provide silicone for the
outer jacket only. Some
wire manufacturers even try to advertise a bigger diameter wire (i.e. 9mm)
trying to make you think that Bigger is Better while the main part of their
insulation is made up of an inferior material which does not provide
protection against voltage leaks.
If it doesn't say
Don't be fooled!
European wire sets utilize OE parts from Bremi Fahrzeug- Elektrik of
BREMI is an original equipment supplier of Ignition parts for Audi, Bentley,
BMW, Mercedes & Volkswagen. Most of our European wire sets are assembled in
Southfields NY USA, with the finest copper core silicone wire which greatly
exceeds O.E. and competitor specifications. This double extruded
Silicone-over-Silicone wire contains
19 strands of
tinned copper core which
provides "super conductivity" with superior corrosion resistance.
Our wire sets always include
O.E. Type Connectors,
Looms, Sensors, Harness Clips & Heat/Abrasion Shields whenever needed. This
results in a state-of-the-art wire set which will excite the installer and
the automotive enthusiast.
This line features German Engineered
Spark Plug Connectors, specially designed durable boots, corrosion
resistant and oversized clip-lock terminals which allow for positive
electrical connection every time you install or reinstall them. Our
8.0mm Silicone-over-Silicone cable includes two layers
of Silicone for superior voltage protection.
STI uses proper distributor angle Terminals
|STI's 90 Degree distributor
boots are equipped with 90 degree terminals. This allows for a
positive feel of an electrical connection every time you install or
reinstall them. Other Brands provide a 90 degree distributor
boot, but NOT a 90 degree terminal. (See the picture
with the Red Wire) When you install their boot on a distributor cap it
has a springy feel because you are actually pushing on the wire inside
requiring 3 piece Spark Plug Connectors,
our wire sets come equipped with German Engineered plug connectors with an
improved design over O.E. Our Plug Connectors come with the Silicone Tip
mounted permanently to the connector without glue! The original OE
design, is glued. Upon removing glued Spark Plug Connectors, the Silicone
Tips can come off & get stuck deep in the well making it incredibly
difficult to remove. Our permanently mounted Spark Plug Tips also have a
unique design that allows for a tight plug seal, even on Spark Plugs with
different diameters. Our Terminals are permanently locked inside
the spark plug connector to insure a perfect fit every time you install or
wire sets use stainless steel magnetic conductive windings for applications
which can handle extra fire power to reach the spark plugs. This
results in improved gas mileage and superior engine performance, while it
prevents radio frequency noise from interfering with radios, cellular
telephones, TV's, computers and other onboard electronic equipment.
Please note that Spiro Core
"Mag" wire is not recommended for European Applications.
To go to our Catalog
Home | Products | Karlyn Profile | Bremi
Profile | Catalog | What's New